Search found 10 matches
- Thu Mar 07, 2019 2:47 am
- Forum: 3DP printing
- Topic: The Z400 adventure
- Replies: 10
- Views: 46976
Re: The Z400 adventure
should be interesting
- Thu Sep 21, 2017 7:17 am
- Forum: 3DP printing
- Topic: Zprint 7.10 or 310+ heater activation
- Replies: 6
- Views: 23729
Re: Zprint 7.10 or 310+ heater activation
hi as far as a warning that comes up the printhead is about worn out and that timing is set in the software. But it is pretty close to what a brand-new printhead is it usually does not last much longer than that. On an older printhead that's set around and expired, I've been having a lot of trouble ...
- Wed Sep 20, 2017 8:17 am
- Forum: 3DP printing
- Topic: Zprint 7.10 or 310+ heater activation
- Replies: 6
- Views: 23729
Re: Zprint 7.10 or 310+ heater activation
There i believe is a preheat function in the software.
- Wed Sep 20, 2017 8:15 am
- Forum: 3DP printing
- Topic: Zprint 7.10 or 310+ heater activation
- Replies: 6
- Views: 23729
Re: Zprint 7.10 or 310+ heater activation
Go in and maunaly make up the powder , if need be. BTW what are you doing for print heads?
- Fri Sep 15, 2017 3:19 am
- Forum: 3DP printing
- Topic: Hacking the HP45
- Replies: 757
- Views: 2937858
Re: Hacking the HP45
nice
- Sun May 07, 2017 10:48 pm
- Forum: 3DP printing
- Topic: ZCorp 310 +
- Replies: 15
- Views: 54685
Re: ZCorp 310 +
most powders are set to 90 degrees f. i let mine sit for a few hours than bake in the oven at 300 degrees f. am using hydroperm and pva. do not get it too wet.
- Sat Apr 08, 2017 6:41 am
- Forum: 3DP printing
- Topic: Using a zcorp printer and modifing it for a different print head
- Replies: 5
- Views: 15343
Re: Using a zcorp printer and modifing it for a different print head
Hi Wanko
And where does one find the software?
And where does one find the software?
- Fri Mar 31, 2017 9:57 pm
- Forum: 3DP printing
- Topic: Using a zcorp printer and modifing it for a different print head
- Replies: 5
- Views: 15343
Re: Using a zcorp printer and modifing it for a different print head
How long do you think the Xaar head will last
- Fri Mar 31, 2017 7:39 pm
- Forum: 3DP printing
- Topic: Using a zcorp printer and modifing it for a different print head
- Replies: 5
- Views: 15343
Using a zcorp printer and modifing it for a different print head
Has anyone tried this since the hp10 printhead is no longer good or aviable .
- Fri Mar 10, 2017 11:11 pm
- Forum: 3DP printing
- Topic: Z-Corp 310+ Operating system needed
- Replies: 6
- Views: 24383
Re: Z-Corp 310+ Operating system needed
I have a z310 drive need to figure out how to get it off