Page 2 of 2

Re: GlaDOS lamp

Posted: Mon Jul 09, 2018 4:23 pm
by dragonator
If I am not mistaken you mean the countersunk screw that sits in the mounting plate on top of the gear (attached, circled red).

This screw is not designed to screw into the servo, It only provides support and prevents the gears from spreading apart. You mount the small M2-M3 screw of the servo wheel through the bearing, and then you mount the plate on top of this. The 16mm screw is only attached to the plate, and fits through the bearing bore to provide additional support.

If you have any more questions feel free to ask.

-Yvo

Re: GlaDOS lamp

Posted: Tue Jul 30, 2019 1:41 pm
by lordpreto
Can this be printed with PLA?

Re: GlaDOS lamp

Posted: Tue Jul 30, 2019 3:59 pm
by dragonator
I don't see why not. PET would be better, but I printed it mostly in PLA