Search found 10 matches

by frankie
Thu Mar 07, 2019 2:47 am
Forum: 3DP printing
Topic: The Z400 adventure
Replies: 10
Views: 1941

Re: The Z400 adventure

should be interesting
by frankie
Thu Sep 21, 2017 7:17 am
Forum: 3DP printing
Topic: Zprint 7.10 or 310+ heater activation
Replies: 6
Views: 4552

Re: Zprint 7.10 or 310+ heater activation

hi as far as a warning that comes up the printhead is about worn out and that timing is set in the software. But it is pretty close to what a brand-new printhead is it usually does not last much longer than that. On an older printhead that's set around and expired, I've been having a lot of trouble ...
by frankie
Wed Sep 20, 2017 8:17 am
Forum: 3DP printing
Topic: Zprint 7.10 or 310+ heater activation
Replies: 6
Views: 4552

Re: Zprint 7.10 or 310+ heater activation

There i believe is a preheat function in the software.
by frankie
Wed Sep 20, 2017 8:15 am
Forum: 3DP printing
Topic: Zprint 7.10 or 310+ heater activation
Replies: 6
Views: 4552

Re: Zprint 7.10 or 310+ heater activation

Go in and maunaly make up the powder , if need be. BTW what are you doing for print heads?
by frankie
Fri Sep 15, 2017 3:19 am
Forum: 3DP printing
Topic: Hacking the HP45
Replies: 509
Views: 290797

Re: Hacking the HP45

nice
by frankie
Sun May 07, 2017 10:48 pm
Forum: 3DP printing
Topic: ZCorp 310 +
Replies: 15
Views: 19710

Re: ZCorp 310 +

most powders are set to 90 degrees f. i let mine sit for a few hours than bake in the oven at 300 degrees f. am using hydroperm and pva. do not get it too wet. :D
by frankie
Sat Apr 08, 2017 6:41 am
Forum: 3DP printing
Topic: Using a zcorp printer and modifing it for a different print head
Replies: 5
Views: 5538

Re: Using a zcorp printer and modifing it for a different print head

Hi Wanko

And where does one find the software?
by frankie
Fri Mar 31, 2017 9:57 pm
Forum: 3DP printing
Topic: Using a zcorp printer and modifing it for a different print head
Replies: 5
Views: 5538

Re: Using a zcorp printer and modifing it for a different print head

How long do you think the Xaar head will last
by frankie
Fri Mar 31, 2017 7:39 pm
Forum: 3DP printing
Topic: Using a zcorp printer and modifing it for a different print head
Replies: 5
Views: 5538

Using a zcorp printer and modifing it for a different print head

Has anyone tried this since the hp10 printhead is no longer good or aviable .
by frankie
Fri Mar 10, 2017 11:11 pm
Forum: 3DP printing
Topic: Z-Corp 310+ Operating system needed
Replies: 6
Views: 6165

Re: Z-Corp 310+ Operating system needed

I have a z310 drive need to figure out how to get it off