Search found 6 matches

by ghvanhoosesr
Fri Jan 20, 2023 9:24 pm
Forum: 3DP printing
Topic: Hacking the HP45
Replies: 749
Views: 2889750

Re: Hacking the HP45

Actually I think it may have something to do with the pogo pins not connecting properly. Is that a common occurrence? (and if so is there a fix?)
by ghvanhoosesr
Wed Jan 18, 2023 3:05 am
Forum: 3DP printing
Topic: Hacking the HP45
Replies: 749
Views: 2889750

Re: Hacking the HP45

I do not have any capability to test the addresses on the board.
by ghvanhoosesr
Sat Jan 14, 2023 5:40 pm
Forum: 3DP printing
Topic: Hacking the HP45
Replies: 749
Views: 2889750

Re: Hacking the HP45

Here's a prime I did with a small number of pulses (only about 10 or 20 I think, I don't precisely remember) Again I was holding it by hand so there may have been a small amount of shakiness on my part.
Let me know if you need something more detailed.
by ghvanhoosesr
Sat Jan 14, 2023 4:41 am
Forum: 3DP printing
Topic: Hacking the HP45
Replies: 749
Views: 2889750

Re: Hacking the HP45

Thank you for getting back to me so quickly! I cleaned the head as advised, and Test Head returns 300/300. The stripe issue still persists. After cleaning and testing the head I ran a prime cycle, while moving a piece of paper under the printhead by hand. A photo of the results are attached here. Wh...
by ghvanhoosesr
Fri Jan 13, 2023 4:17 pm
Forum: 3DP printing
Topic: Hacking the HP45
Replies: 749
Views: 2889750

Re: Hacking the HP45

Greetings Dragonator, With the V3 printhead controller, is there anything that can be done for a problem where it looks like some nozzles are firing and some aren't? I've gone through and verified the addresses and primitives are being sent on the software side. (the controls for the address latch a...
by ghvanhoosesr
Tue Nov 15, 2022 3:53 pm
Forum: 3DP printing
Topic: Hacking the HP45
Replies: 749
Views: 2889750

Re: Hacking the HP45

Greetings Dragonator! I'm having a doozie of a time trying to get this HP45 printhead and controller to work with Inkjet Commander. I only have the older hardware in front of me; specifically, the HP45 Standalone V3.01 Controller. From going through the code for both HP45_Standalone V3 and Inkjet Co...