Ytec3D Forum

Once again, dummy1 is not rising. This time there is no misalignment, and it was working fine yesterday as well. Should I replace IC4

Thanks for your prompt response. While I did observe that the virtual buffer read left decreases as you mentioned, I only see a small purge. I've noticed that when I apply preheat, it purges the ink out of the cartridge quite quickly, whereas when I apply preheat, it ejects very little. I'll share t...

Hello Yes, that's the issue thanks : the IC4 pin is slightly misaligned. The 300/300 nozzle is currently displaying a temperature of around 40-50°C. I am able to eject the ink while applying preheat, but I am unable to print when sending the image. However, I am able to view the data in the terminal...

When I run the Inkjet Commander application, I'm greeted with a perplexing 'Dummy 2 not rising' error. Additionally, the test head's reading is puzzling, showing 50/300, which is far from expected. For context, I'm utilizing a B3F38A Black cartridge in this setup.
Standalone controller Version 4.02