Search found 4 matches
- Wed Feb 28, 2024 11:17 am
- Forum: 3DP printing
- Topic: Dummy 2 not rising error
- Replies: 7
- Views: 3817
Re: Dummy 2 not rising error
Once again, dummy1 is not rising. This time there is no misalignment, and it was working fine yesterday as well. Should I replace IC4
- Tue Feb 27, 2024 6:33 am
- Forum: 3DP printing
- Topic: Dummy 2 not rising error
- Replies: 7
- Views: 3817
Re: Dummy 2 not rising error
Thanks for your prompt response. While I did observe that the virtual buffer read left decreases as you mentioned, I only see a small purge. I've noticed that when I apply preheat, it purges the ink out of the cartridge quite quickly, whereas when I apply preheat, it ejects very little. I'll share t...
- Mon Feb 26, 2024 9:12 am
- Forum: 3DP printing
- Topic: Dummy 2 not rising error
- Replies: 7
- Views: 3817
Re: Dummy 2 not rising error
Hello Yes, that's the issue thanks : the IC4 pin is slightly misaligned. The 300/300 nozzle is currently displaying a temperature of around 40-50°C. I am able to eject the ink while applying preheat, but I am unable to print when sending the image. However, I am able to view the data in the terminal...
- Sat Feb 24, 2024 5:43 am
- Forum: 3DP printing
- Topic: Dummy 2 not rising error
- Replies: 7
- Views: 3817
Dummy 2 not rising error
When I run the Inkjet Commander application, I'm greeted with a perplexing 'Dummy 2 not rising' error. Additionally, the test head's reading is puzzling, showing 50/300, which is far from expected. For context, I'm utilizing a B3F38A Black cartridge in this setup.
Standalone controller Version 4.02
Standalone controller Version 4.02