Ytec3D Forum

Wonko how to watch the analog range?

I would recommend that you look at all the signals with an analog scope as well

why do you think that this can be analog?

closer

I made a more detailed digital sample and it covered the whole time of the whole printing I'm sure that 9 and 13 are responsible for the left and right row of nozzles One can see on the oscillograph the ninth terminates faster than the thirteenth this is the same oscillogram with each photo scale in...

Here is more detailed measured and checked
previous ignore there many mistakes made
I checked the file again and corrected errors

Is it possible that 9 and 13 are responsible for the right and left nozzles, and not to the top and bottom? you said (I suspect that the gap in 3 columns is more than 4 mm) what did you mean what do the trigger contacts do or where I can read about it? but the photos of the logical analyzer of the n...

perhaps the speed of the shield of the analyzer was small and therefore the clock did not catch

Here's how the cartridge divides the nozzles into print
I pulled out the cable from the outlet
the printer prints a black square