Page 1 of 1

Megatronics v3.2 Issues

Posted: Fri Feb 15, 2019 10:30 pm
by GMO_Taco

I've been working on my own Plan B printer now for the last few months. I'm about 90% finished with the build, but I ran into an issue. I bought the Megatronics v3.2 board and it turns out it's not compatible with the keyboard. I found a potential solution but I'm having trouble adjusting the plan b firmware to account for the fix. Here is the link to the potential solution- Any help would be greatly appreciated.


Re: Megatronics v3.2 Issues

Posted: Mon Feb 18, 2019 6:40 am
by dragonator
Do you know what the physical difference is between the header on the V3.2 and the V3.1. I did read through the document a little, but it only mentions what the fix is, and not the problem, and I have difficulty figuring out what is causing you issues.