Standalone controller V4.0

Powder and inkjet printing
Priyashree
Posts: 10
Joined: Wed Jul 17, 2019 8:40 am

Re: Standalone controller V4.0

Post by Priyashree »

@Dragonator Printing quality is seems okay compare to previous oasis 3dp version. Any special requirement of spi protocol. I think it's reducing the pinouts but increase the source code complexity.
User avatar
dragonator
Site Admin
Posts: 502
Joined: Fri Aug 14, 2015 4:48 pm
Location: The Nethelands
Contact:

Re: Standalone controller V4.0

Post by dragonator »

Printing quality is better than the last shown images. In the images the encoder was not calibrated. Printing quality is the same as with any other printer.

SPI is not yet implemented. I still do not have that much experience with SPI, so any protocol I would write would be written with no eye on actually using it. It should be fairly doable though. The source code will of course get bigger, but since you only print either SPI or serial, the actual code should not run much slower.
Post Reply