ZCorp 310 +

Powder and inkjet printing
n.moslem
Posts: 1
Joined: Sun Nov 27, 2016 4:40 pm

Re: ZCorp 310 +

Post by n.moslem » Sun Nov 27, 2016 4:43 pm

Hi can you post some photos of the roller and...? 8-) 8-) 8-)

verguetz
Posts: 1
Joined: Sun Dec 18, 2016 8:49 pm

Re: ZCorp 310 +

Post by verguetz » Sun Dec 18, 2016 9:17 pm

Hello Ezrec,
I have two zprinters, 310 and 510. I'm having a hard time making printhead control standalone. In your research you have found some specific material of the heads hp10 and 11, like electrical schematic, driving times or control information ?? I will be grateful if I can share your knowledge. Att., Verguetz

User avatar
Skynetbeta
Posts: 4
Joined: Thu Dec 29, 2016 8:03 pm

Re: ZCorp 310 +

Post by Skynetbeta » Thu Dec 29, 2016 8:07 pm

Question I have a zcorp 310+ with a dead IDE flash drive.
Would you be able to send me a copy of your machines drive so I could restore mine?

frankie
Posts: 10
Joined: Wed Nov 16, 2016 11:34 pm

Re: ZCorp 310 +

Post by frankie » Sun May 07, 2017 10:48 pm

most powders are set to 90 degrees f. i let mine sit for a few hours than bake in the oven at 300 degrees f. am using hydroperm and pva. do not get it too wet. :D

3DTOPO
Posts: 2
Joined: Fri Jan 18, 2019 2:18 am

Re: ZCorp 310 +

Post by 3DTOPO » Fri Jan 18, 2019 6:36 pm

Greetings,

I purchased a broken 310 - has excessive a "axis 1 excessive position error". I rebuilt the fast carriage, replaced the belt, but still get the error. I figure it must be the servo - have a new one on order.

My printer came with the parking cap missing. Can someone please get me dimensions so I can print a new part? I can't find replacement parts anywhere. I could print a mold to cast a rubber cap. There is a sping in the service station for it, so the other part(s) could be 3D printed if I had dimensions.

Image

3DTOPO
Posts: 2
Joined: Fri Jan 18, 2019 2:18 am

Re: ZCorp 310 +

Post by 3DTOPO » Wed Jan 30, 2019 12:09 am

I hope its OK to post this here. Please remove if not.

I couldn't find any forums dedicated to ZPrinters so I started one:

http://zprinterforum.com

Hope to see you all there!

Post Reply