Hi,
I am trying to print ceramic parts. I am using tethon3D binder. But clogged nozzle is very big problem. Is tethon3D binder not good for HP C6602? Or is there another problem? What can I do for clogged nozzle?
Printing Ceramic Parts
- dragonator
- Site Admin
- Posts: 607
- Joined: Fri Aug 14, 2015 4:48 pm
- Location: The Nethelands
- Contact:
Re: Printing Ceramic Parts
Hello,
Starting with what it is you do exactly. I presume you have bought Tethon binder jetting powders and are using Tethonite Binder (https://tethon3d.com/product/binder/). You are not using any of the resins Tethon sells, which are for SLA/DLP printing.
The C6602 should in principle be able to print the binder. The HP45 can print it, and it has smaller nozzles than the C6602. Have you tried with more than one printhead? How did you clean the head before you filled the C6602? Is it possible you damages something here?
Clogged nozzles are best cleaned using Isopropylalcohol or some other high percentage alcohol. If you thoroughly apply this with a paper towel the ink or binder clogging the nozzles should dissolve.
Starting with what it is you do exactly. I presume you have bought Tethon binder jetting powders and are using Tethonite Binder (https://tethon3d.com/product/binder/). You are not using any of the resins Tethon sells, which are for SLA/DLP printing.
The C6602 should in principle be able to print the binder. The HP45 can print it, and it has smaller nozzles than the C6602. Have you tried with more than one printhead? How did you clean the head before you filled the C6602? Is it possible you damages something here?
Clogged nozzles are best cleaned using Isopropylalcohol or some other high percentage alcohol. If you thoroughly apply this with a paper towel the ink or binder clogging the nozzles should dissolve.
Re: Printing Ceramic Parts
Yes I use tethonite binder, not using any resin like photopolimer. I use isopropyl alcohol but i can't cleen the nozzle. I broke a lot of nozzle .
- dragonator
- Site Admin
- Posts: 607
- Joined: Fri Aug 14, 2015 4:48 pm
- Location: The Nethelands
- Contact:
Re: Printing Ceramic Parts
It has been a while since I worked with the C6602. I know that the nozzles are in a metal plate which is fragile. If you are going to give it another try I would first print with the printhead to make sure it works before making another attempt. Also you can try and fill the printhead with something like 30-40% alcohol, the rest distilled water. This should be a fairly save mix to print, and should work.
Other than that, I do not have much more to offer. I have only tried Tethonite binder in the HP45, but the HP45 is more robust and easier to refill. It has been years since I refilled an HP45.
Other than that, I do not have much more to offer. I have only tried Tethonite binder in the HP45, but the HP45 is more robust and easier to refill. It has been years since I refilled an HP45.
Re: Printing Ceramic Parts
Thank you for everything
Re: Printing Ceramic Parts
Hi, hsnbas. Did you manage to make the boost demultiplexer work properly? If so, can you share your email address with me, I have a few questions I'd like to ask. Could you please help me?