Page 2 of 2
Re: ZCorp 310 +
Posted: Sun Nov 27, 2016 4:43 pm
by n.moslem
Re: ZCorp 310 +
Posted: Sun Dec 18, 2016 9:17 pm
by verguetz
Hello Ezrec,
I have two zprinters, 310 and 510. I'm having a hard time making printhead control standalone. In your research you have found some specific material of the heads hp10 and 11, like electrical schematic, driving times or control information ?? I will be grateful if I can share your knowledge. Att., Verguetz
Re: ZCorp 310 +
Posted: Thu Dec 29, 2016 8:07 pm
by Skynetbeta
Question I have a zcorp 310+ with a dead IDE flash drive.
Would you be able to send me a copy of your machines drive so I could restore mine?
Re: ZCorp 310 +
Posted: Sun May 07, 2017 10:48 pm
by frankie
most powders are set to 90 degrees f. i let mine sit for a few hours than bake in the oven at 300 degrees f. am using hydroperm and pva. do not get it too wet.
Re: ZCorp 310 +
Posted: Fri Jan 18, 2019 6:36 pm
by 3DTOPO
Greetings,
I purchased a broken 310 - has excessive a "axis 1 excessive position error". I rebuilt the fast carriage, replaced the belt, but still get the error. I figure it must be the servo - have a new one on order.
My printer came with the parking cap missing. Can someone please get me dimensions so I can print a new part? I can't find replacement parts anywhere. I could print a mold to cast a rubber cap. There is a sping in the service station for it, so the other part(s) could be 3D printed if I had dimensions.
Re: ZCorp 310 +
Posted: Wed Jan 30, 2019 12:09 am
by 3DTOPO
I hope its OK to post this here. Please remove if not.
I couldn't find any forums dedicated to ZPrinters so I started one:
http://zprinterforum.com
Hope to see you all there!