Hacking the Xaar 128 printhead

Powder and inkjet printing
aengel
Posts: 34
Joined: Fri Mar 16, 2018 2:05 pm

Re: Hacking the Xaar 128 printhead

Post by aengel » Fri May 03, 2019 3:32 pm

Triton uv curing inks for inkjet :

https://www.tritron.eu/1/produkte/marki ... chriftung/

Kao Collins uv curing inks for inkjet headquartered in Cincinnati Ohio USA

https://www.kaocollins.com/inks/uv-curable-ink/

maxt
Posts: 7
Joined: Fri Apr 26, 2019 10:38 am

Re: Hacking the Xaar 128 printhead

Post by maxt » Sun May 05, 2019 4:58 pm

aengel and wonko, thank you both for the references.

however I assume that neither of you has succesfully printed with an UV ink with the XAAR-128 ? and not with a water based ink ?

thanks
Massimo

Wonko
Posts: 83
Joined: Sat Aug 15, 2015 8:13 pm

Re: Hacking the Xaar 128 printhead

Post by Wonko » Mon May 06, 2019 6:58 pm

I have only tried solvent based ink, yes. Tritron V Photon black is a suggestion from the Xaar ink recommendation list specifically for the 128, but who knows if that list is correct. This is the only UV ink mentioned there. Water based ink fails for me completely. It took me forever to find that out when I connected the head the first time. I doubted my power electronics, my connections, my data logic, my uC programming, until changing to solvent based ink proved that I did everything correctly from the beginning - except choosing the right ink.

davidk
Posts: 63
Joined: Sun Mar 12, 2017 6:48 pm

Re: Hacking the Xaar 128 printhead

Post by davidk » Mon May 06, 2019 7:07 pm

I know. I made the same mistakes and assumptions and lost two printheads by running water and aqueous ink. The irony is for me solvent ink was exactly what I needed. And it never clogs...

maxt
Posts: 7
Joined: Fri Apr 26, 2019 10:38 am

Re: Hacking the Xaar 128 printhead

Post by maxt » Thu May 09, 2019 10:52 am

hi,
and thank you for avoiding me a lot of troubles... I'll have to look into the solvent based inks, if they fit my application. Certeinly not for the plaster powder... Any clue what kind of solvent are these inks based on ?
thanks
Massimo

Braden
Posts: 4
Joined: Sun Aug 12, 2018 5:42 pm

Re: Hacking the Xaar 128 printhead

Post by Braden » Thu May 16, 2019 7:57 pm

davidk,

Could you please send me some pics of your ink supply system? I am trying to use an espon ink damper in my design such as you but cannot seem to get consistent ink flow without air bubbles in my hose lines. Specifically, I either get way too much ink flow and ink bleeds a lot or I get way too little ink flow and have big air bubbles in my supply line. I am trying to use a gravity fed ink supply system instead of a vacuum fed one in order to save money and time on the design.

Thanks for the help,

Braden

Post Reply