Good ol' plastic extrusion
1 post • Page 1 of 1
Always looking for ways to improve my printers, I decided to try a rack and pinion system for one of the printers' y-axis. I used a polyurethane/steel reinforced 6mm gt2 belt (indestructible), put it alongside a hardened 6mm rod, stretched it REALLY tight, and ran it over a 16t gt2 drive gear. I used a pressure idler with spring tensioner positioned directly above the drive gear. Just printed a 100mm x 100mm bed test print at 40mm/s and it performed spot on. no more belt tensioning on this printer!
- DSCF0203 (2)-640x480.jpg (76.7 KiB) Viewed 18620 times