NC connected instead of NO in demux circuit
Posted: Fri Jun 24, 2022 8:06 pm
Hi,
My team already connect the boost safety connection correctly according to the instruction (the LED on the demux circuit lights up when printing) but we encountered a problem that the ink was not extruded. The ink would only be extruded when we disconnect the boost safety connection. Is there any way for us to rectify this situation/problem? We used G5V-1-DC5 (Form C SPDT) like what you did that were included the DIY version of demux but we’re not sure how to set the NC connector of the relay to the NO part. Should we use another type of relay or is there anyway for us to change the connection of the circuit to rectify this?
Thank you for your help.
My team already connect the boost safety connection correctly according to the instruction (the LED on the demux circuit lights up when printing) but we encountered a problem that the ink was not extruded. The ink would only be extruded when we disconnect the boost safety connection. Is there any way for us to rectify this situation/problem? We used G5V-1-DC5 (Form C SPDT) like what you did that were included the DIY version of demux but we’re not sure how to set the NC connector of the relay to the NO part. Should we use another type of relay or is there anyway for us to change the connection of the circuit to rectify this?
Thank you for your help.