Reply To: Step 1, Hacking the CN642A inkjet printhead

Home › Forums › 3DP printing › Step 1, Hacking the CN642A inkjet printhead › Reply To: Step 1, Hacking the CN642A inkjet printhead

September 15, 2014 at 9:59 pm #1613
wonko
Participant

I created a little breakout board. What do you think? I have not printed it out to scale for testing yet.

InkHead BreakOut

The Eagle files are here

The Holes should be a little bit over 1mm in diameter so that the pogo pins will fit. However, it would be nice to have that checked in a peer review before I send the files to a PCB maker.